PUCEM TF

Configure your own floor

PUCEM TF is being used in the following systems:

Description

The Eurostep PUCEM TF infill system is a 4-12 mm floor finish consisting of a combination of polyurethane and cement. The PUCEM TF infill system (infill material such as quartz sand) is often used in the industrial sector.

- The PUCEM TF infill system is wear-resistant and heavy-duty.
- The infill material provides anti-slip, making it safe to walk on wet floors.
- PUCEM TF is liquid-proof and highly resistant to chemicals, oils and solvents.
- The seamless finish also provides an easy-to-clean surface that is hygienic and meets the strictest food safety standards.
- Extremely heat resistant and can therefore withstand hot water.
- Rapid build-up of high strength in a short time

Summary
PUCEM TF infill system is a robust, strong and decorative floor that is heavy duty and easy to clean. Suitable for industries such as factories, garages and workshops.

- For the technical description see: TDS
- For optimal application of PUCEM TF infill system, follow the manual.
Pay particular attention to this (the instructions in a nutshell)!
1. Thoroughly clean and degrease the substrate. Do not apply the product if the floor temperature is below 15° Celsius.
2. (Diamond) sanding or blasting removes the cement residue.
3. Pour the A-component into a bucket and add the pigment paste.
4. Then add the entire contents of the B component to the A component and pigment.
5. Mix for 30 seconds until a homogeneous mixture is formed.
6. Add the filler and mix thoroughly for 1 minute until a lump-free mixture is formed.
7. Pour out the mixture and spread it evenly over the subfloor with Tooth Strip 28cm, 4700-280-S 10. Let it flow for about 10 minutes before you start spreading. Always pour the entire contents of the bucket at once to prevent rapid reaction of material in the bucket.
8. Depending on the desired anti-slip level, sprinkle full and saturated with 0.4 - 0.8 mm or 0.8 - 1.2 mm quartz.
9. When the PUCEM TF has been applied, the floor should cure for about 10 hours.
10. Remove excess quartz from the floor and resand with a rotary parquet sander if necessary. ALWAYS finish the floor with PUCEM L

Datasheets