PUCEM HF

Configure your own floor

PUCEM HF is being used in the following systems:

Description

The Eurostep PUCEM HF trowel system is a floor finish of 8-12 mm that consists of a combination of polyurethane and cement. The PUCEM HF trowel system is often used in the industrial sector.

• The PUCEM HF trowel system is wear-resistant and heavy-duty
• The infill material provides anti-slip making it safe to walk on a wet floor.
• PUCEM HF is liquid-tight and has excellent resistance to chemicals, oils and solvents
• The seamless finish also provides an easy-to-clean surface that is hygienic
• Extremely heat resistant and can therefore withstand hot water
• Can be lubricated under a slope
• The PUCEM HF trowel system adheres directly to the substrate and can be applied in one go without a primer

• For the technical description, see: TDS
• Follow the manual for optimal application of PUCEM HF.
Pay particular attention to this (the manual in a nutshell)!
1. Clean and degrease the surface thoroughly. Do not apply the product at a floor temperature below 15° Celsius.
2. The cement veil disappears by (diamond) sanding or blasting.
3. Pour the A-component into a bucket and add the pigment paste.
4. Then add the entire contents of the B component to the A component and the pigment.
5. Mix for 30 seconds until a homogeneous mixture.
6. Add the filler and mix thoroughly for 1 minute until a lump-free mixture is formed.
7. Pour the mixture and spread it evenly over the subfloor with a floor trowel. Always pour the entire contents of the bucket at once to prevent a rapid reaction of material in the bucket.
8. Roll with a nylon fleece roller to roll away the application marks from the floor trowel.
9. Once the PUCEM HF has been applied, the floor must harden for approximately 10 hours.

Datasheets